米沃奇m12冲击起子机2604-20,爆炸图,分解图c

4. Route the wire over the three wires on the right side of switch and thread

wire through existing wire tie (See detail to the right). Note: If wire tie is too

tight to slip high voltage wire through, carefully snip that wire tie off and

replace with a new small wire tie (23-78-0100) to secure all four wires right

below the switch.

5. Place the ring terminal of the new HV wire assembly over the hole in gearcase.

Orient the terminal so wire feeds to the left across the bottom of the gearcase and secure with the gearcase screw.