欣瑞达电子
X.R.D ELECTRONIC CO.,LTD SPECIFICATIONS FOR LCD
MODULE
地址:深圳市宝安区石岩镇水田长城路鼎丰科技园E栋2-3楼
电话:0755-29519354 29519834
Specification Revision History
CONTENTS
? MODULE CLASSIFICATION INFORMATION ? PHYSICAL DATA
? MECHANICAL DIMENSIONS
? BLOCK DIAGRAM
? INTERFACE PIN CONNECTIONS
? ABSOLUTE MAXIMUM RATINGS
? ELECTRICAL CHARACTERISTICS
? BACKLIGHT
? OPTICAL CHARACTERISTICS
? OPERATING PRINCIPLES METHODS
? DISPLAY DATA RAM ADDRESS MAP
? GRAPHIC RAM
?INTERFACE
? COMMAND
? POWER SUPPLY FOR LCM MODULE
? EXAMPLE
? RELIABILITY
? INSPECTION CRITERIA
? PRECAUTIONS FOR USING LCD MODULES ? USING LCD MODULES
MODULE CLASSIFICATION INFORMATION
?PHYSICAL DATA
? MECHANICAL DIMENSIONS
BLOCK DIAGRAM
INTERFACE PIN CONNECTIONS
? ELECTRICAL CHARACTERISTICS
DC Characteristics
AC Characteristics
BACKLIGHT
Backlight Type
Backlight Type: LED (WHITE) Power Supply For Backlight (LED Chip 3dies)
K
A
Absolute Maximum Rating
℃,Then Ifm Ifp must be decreased, the Current decreased is -1.08mA/℃ for DC
drive and -2.58mA/℃ Pulse drive, the power dissipation is -4.5m W/℃.The product working current must not more than the 70% of the Ifm or Ifp according to the working temperature.
Electrical-Optical Characteristics
Note:The Master Screen ’s luminance is the average value of 5 points,and The Lvmin./Lvmax. is not less than 70%. The measurement instrument is BM-7 luminance Colorimeter. The aperture is Φ5 mm.
OPTICAL CHARACTERISTICS
Definition Of Viewing Angle
Note1: Definition of response time
Note2: Definition of contrast ratio ‘C r’Note3: Definition of viewing angle range ‘θ’
Note4:Measuring Instruments For Electro-optical Characteristics
*1.Light source position for measuring the reflective type of LCD panel
*2.Light source position for measuring the transflective / transmissive types of LCD pane l
? OPERATING PRINCIPLES METHODS
Reset
System reset can be initialized by setting RSTB terminal at low level when turning power on, receiving instruction from MPU. When RSTB becomes low, following procedure is occurred.
- Display off
- Display start line register becone set by 0.(Z-address 0)
Table 1. Power Supply Initial Conditions
? DISPLAY DATA RAM ADDRESS MAP
? GRAPHIC RAM