搜档网
当前位置:搜档网 › ap16_frq_chemistry

ap16_frq_chemistry

ap16_frq_chemistry
ap16_frq_chemistry

AP? Chemistry

2016 Free-Response Questions

? 2016 The College Board. College Board, Advanced Placement Program, AP, AP Central, and the acorn logo are registered trademarks of the College Board.

Visit the College Board on the Web: https://www.sodocs.net/doc/e51175476.html,.

AP Central is the official online home for the AP Program: https://www.sodocs.net/doc/e51175476.html,.

AP? CHEMISTRY EQUATIONS AND CONSTANTS Throughout the exam the following symbols have the definitions specified unless otherwise noted.

L, mL = liter(s), milliliter(s) mm Hg = millimeters of mercury

g = gram(s) J, kJ = joule(s), kilojoule(s)

nanometer(s) V = volt(s)

nm =

=

mole(s)

atmosphere(s) mol

=

atm

"1¥ $)&.*453: '3&& 3&410/4& 26&45*0/4

CHEMISTRY

Section II

7 Questions

Time—1 hour and 45 minutes

YOU MAY USE YOUR CALCULATOR FOR THIS SECTION.

Directions: Questions 1–3 are long free-response questions that require about 23 minutes each to answer and are worth 10 points each. Questions 4–7 are short free-response questions that require about 9 minutes each to answer and are worth 4 points each.

Write your response in the space provided following each question. Examples and equations may be included in your responses where appropriate. For calculations, clearly show the method used and the steps involved in arriving at your answers. You must show your work to receive credit for your answer. Pay attention to significant figures.

1. A student investigates the enthalpy of solution,ΔH soln, for two alkali metal halides,LiCl and NaCl. In addition

to the salts, the student has access to a calorimeter, a balance with a precision of ±0.1 g, and a thermometer with

a precision of ±0.1°C.

(a) To measureΔH soln for LiCl, the student adds 100.0 g of water initially at 15.0°C to a calorimeter and adds

10.0 g of LiCl(s), stirring to dissolve. After the LiCl dissolves completely, the maximum temperature

reached by the solution is 35.6°C.

(i) Calculate the magnitude of the heat absorbed by the solution during the dissolution process, assuming

that the specific heat capacity of the solution is 4.18 J/(g·°C). Include units with your answer.

(ii) Determine the value ofΔH soln for LiCl in kJ/mol rxn.

To explain whyΔH soln for NaCl is different than that for LiCl, the student investigates factors that affect ΔH soln and finds that ionic radius and lattice enthalpy (which can be defined as theΔH associated with the separation of a solid crystal into gaseous ions) contribute to the process. The student consults references and collects the data shown in the table below.

Ion Ionic Radius (pm)

Li+76

Na+102

? 2016 The College Board.

(b) Write the complete electron configuration for the Na + ion in the ground state.

(c) Using principles of atomic structure, explain why the Na + ion is larger than the Li + ion.

(d) Which salt, LiCl or NaCl, has the greater lattice enthalpy? Justify your answer.

(e) Below is a representation of a portion of a crystal of +(Li or Cl ?)LiCl. Identify the ions in the representation by writing the appropriate formulas

in the boxes below.

(f) The lattice enthalpy of LiCl is positive, indicating that it takes energy to break the ions apart in LiCl.

However, the dissolution of LiCl in water is an exothermic process. Identify all particle-particle interactions that contribute significantly to the dissolution process being exothermic. For each interaction, include the particles that interact and the specific type of intermolecular force between those particles.

NaHCO3(s) + HC2H3O2(aq) → NaC2H3O2(aq) + H2O(l) + CO2(g)

2. A student designs an experiment to study the reaction between NaHCO3and HC2H3O2. The reaction is

represented by the equation above. The student places 2.24 g of NaHCO3in a flask and adds 60.0 mL of

0.875 M HC2H3O2. The student observes the formation of bubbles and that the flask gets cooler as the reaction

proceeds.

(a) Identify the reaction represented above as an acid-base reaction, precipitation reaction, or redox reaction.

Justify your answer.

(b) Based on the information above, identify the limiting reactant. Justify your answer with calculations.

(c) The student observes that the bubbling is rapid at the beginning of the reaction and gradually slows as the

reaction continues. Explain this change in the reaction rate in terms of the collisions between reactant

particles.

(d) In thermodynamic terms, a reaction can be driven by enthalpy, entropy, or both.

(i) Considering that the flask gets cooler as the reaction proceeds, what drives the chemical reaction

between NaHCO3(s)and HC2H3O2(aq)? Answer by drawing a circle around one of the choices

below.

Enthalpy only Entropy only Both enthalpy and entropy (ii) Justify your selection in part (d)(i) in terms ofΔG°.

(e) The HCO3?ion has three carbon-to-oxygen bonds. Two of the carbon-to-oxygen bonds have the same

length and the third carbon-to-oxygen bond is longer than the other two. The hydrogen atom is bonded to one of the oxygen atoms. In the box below, draw a Lewis electron-dot diagram (or diagrams) for the HCO3?ion that is (are) consistent with the given information.

(f) A student prepares a solution containing equimolar amounts of HC2H3O2and NaC2H3O2. The pH of

the solution is measured to be 4.7. The student adds two drops of 3.0 M HNO3(aq)and stirs the sample, observing that the pH remains at 4.7. Write a balanced, net-ionic equation for the reaction between

HNO3(aq)and the chemical species in the sample that is responsible for the pH remaining at 4.7.

? 2016 The College Board.

"1¥ $)&.*453: '3&& 3&410/4& 26&45*0/4

? 2016 The College Board.

M + I 2 → MI 2

3. To determine the molar mass of an unknown metal, M, a student reacts iodine with an excess of the metal to form the water-soluble compound MI 2, as represented by the equation above. The reaction proceeds until all of the I 2 is consumed. The MI 2(aq ) solution is quantitatively collected and heated to remove the water, and the product is dried and weighed to constant mass. The experimental steps are represented below, followed by a

data table.

(a) Given that the metal M is in excess, calculate the number of moles of I 2 that reacted.

(b) Calculate the molar mass of the unknown metal M.

The student hypothesizes that the compound formed in the synthesis reaction is ionic.

(c) Propose an experimental test the student could perform that could be used to support the hypothesis. Explain

how the results of the test would support the hypothesis if the substance was ionic. Data for Unknown Metal Lab

Mass of beaker

125.457 g Mass of beaker + metal M

126.549 g Mass of beaker + metal M + I 2

127.570 g Mass of MI 2, first weighing

1.284 g Mass of MI 2, second weighing 1.284 g

The student hypothesizes that Br2will react with metal M more vigorously than I2did because Br2is a liquid at room temperature.

(d) Explain why I2is a solid at room temperature whereas Br2is a liquid. Your explanation should clearly

reference the types and relative strengths of the intermolecular forces present in each substance.

While cleaning up after the experiment, the student wishes to dispose of the unused solid I2in a responsible manner. The student decides to convert the solid I2to I?(aq)anion. The student has access to three solutions, H2O2(aq), Na2S2O3(aq), and Na2S4O6(aq), and the standard reduction table shown below.

Half reaction E° (V)

S4O62?(aq) + 2 e?→ 2 S2O32?(aq)0.08

I2(s) + 2 e?→ 2 I?(aq)0.54

O2(g) + 2 H+(aq) + 2 e?→ H2O2(aq)0.68

(e) Which solution should the student add to I2(s)to reduce it to I?(aq)? Circle your answer below. Justify

your answer, including a calculation of E°for the overall reaction.

H2O2(aq)Na2S2O3(aq)Na2S4O6(aq)

(f) Write the balanced net-ionic equation for the reaction between I2and the solution you selected in part (e).

C6H5OH(aq) + H2O(l) →← C6H5O?(aq) + H3O+(aq) K a = 1.12 × 10?10

4. Phenol is a weak acid that partially dissociates in water according to the equation above.

(a) What is the pH of a 0.75 M C6H5OH(aq)solution?

(b) For a certain reaction involving C6H5OH(aq)to proceed at a significant rate, the phenol must be primarily

in its deprotonated form,C6H5O?(aq). In order to ensure that the C6H5OH(aq)is deprotonated, the reaction must be conducted in a buffered solution. On the number scale below, circle each pH for which more than

50 percent of the phenol molecules are in the deprotonated form (C6H5O?(aq)). Justify your answer.

1 234567891011121314

2 C4H6(g) → C8H12(g)

5. At high temperatures the compound C4H6(1,3-butadiene) reacts according to the equation above. The rate of

the reaction was studied at 625 K in a rigid reaction vessel. Two different trials, each with a different starting concentration, were carried out. The data were plotted in three different ways, as shown below.

(a) For trial 1, calculate the initial pressure, in atm, in the vessel at 625 K. Assume that initially all the gas

present in the vessel is C4H6.

(b) Use the data plotted in the graphs to determine the order of the reaction with respect to C4H6.

(c) The initial rate of the reaction in trial 1 is 0.0010 mol/(L?s). Calculate the rate constant, k, for the reaction

at 625 K.

"1¥ $)&.*453: '3&& 3&410/4& 26&45*0/4

? 2016 The College Board.

Ba 2+(aq ) + EDTA 4?(aq ) R Ba(EDTA)2?(aq ) K = 7.7 × 107

6. The polyatomic ion C 10H 12N 2O 84? is commonly abbreviated as EDTA 4?. The ion can form complexes with metal ions in aqueous solutions. A complex of EDTA 4? with Ba 2+ ion forms according to the equation above. A 50.0 mL volume of a solution that has an EDTA 4?(aq ) concentration of 0.30 M is mixed with 50.0 mL of 0.20 M Ba(NO 3)2 to produce 100.0 mL of solution.

(a) Considering the value of K for the reaction, determine the concentration of Ba(EDTA)2?(aq ) in

the 100.0 mL of solution. Justify your answer.

(b) The solution is diluted with distilled water to a total volume of 2+Ba (aq ) 1.00 L. After equilibrium has been

reestablished, is the number of moles of present in the solution greater than, less than, or equal to the number of moles of Ba 2+(aq ) present in the original solution before it was diluted? Justify your answer.

"1¥ $)&.*453: '3&& 3&410/4& 26&45*0/4

7. A student is given a 25.0 mL sample of a solution of an unknown monoprotic acid and asked to determine the concentration of the acid by titration. The student uses a standardized solution of 0.110 M NaOH(aq ), a buret, a flask, an appropriate indicator, and other laboratory equipment necessary for the titration.

(a) The images below show the buret before the titration begins (below left) and at the end point (below right). What should the student record as the volume of NaOH(aq )

delivered to the flask?

(b) Based on the given information and your answer to part (a), determine the value of the concentration of the acid that should be recorded in the student’s lab report.

(c) In a second trial, the student accidentally added more NaOH(aq ) to the flask than was needed to reach the end point, and then recorded the final volume. Would this error increase, decrease, or have no effect on the calculated acid concentration for the second trial? Justify your answer.

STOP

END OF EXAM

相关主题