45度
45度
QA安装一个logger
WI安装
WI安装并检查真空度
/检查
QA验证以后才可以对叶片进行发货
/配重
型主支架
33mm
14-33mm 长度超过1m
not reached before laying the inner root laminate12a-12e层
and may not be copied without permission the board of
WI安装
WI抽样记录
QA部门可以宣布叶片已经制作完成
WI每生产5个叶片以后就使用脱模剂保养模具
清理残留的胶、树脂和薄膜
上模
下模
内部二次层压上模
内部二次层压下模
阻胶法兰前缘/后缘
WI铺层
的尺寸;与主复合层有关的位置
气泡
确认以后完成
型线
QA检查确认以后才可以刷漆
\面重量
WI安装阻胶法兰
1800mm的时候轴向最大允许偏离± 0,2 mm
简短描述等等
位置尺寸
QA检查后才可以对叶根进行切割和打孔
据图纸叶片螺栓的位置及公差
WI搭接
检查后进行合模
QA验证通过后才可使用验证后使用上模叶根加强层
/偏移/裂纹
WI定位和完成
QA检查后才可以使用叶片
WI所述
和SS 叶根加强层的铺层
处叶弦
3层220mm 的二向布组成
4mm 空心螺钉安装0度标识
min. 15 minutes. After complete gluing grout the joints and 30-45度相对于叶片表面the inner opening within the tolerance range as close as
possible before the inner tip-gluing.
打磨和清理表面。使用底漆86A 然后等待15min 。EPX 胶密封。
2层二向布和树脂密封为配重箱所打的孔
主支架上的电缆全部用一层二向布包裹。
800g/m2 (100x200mm) periodical all 1200 mm trailing egde
笔直的铺设防雷电缆,到达棋格板之后在棋格板上
相应位置上钻一个25mm直
径的孔让电缆通过
在电缆尽头安装接头,然后连接在叶根螺栓上,使用一个六角形M8×20的螺栓固定。
Strip 30 mm of the insulation at the LPC's end and press it
on the cable lug. (Use for fixing of the cable lug at the
cable a special press-unit Klauke EK22-plus with insert
m)
42.86mm/m
according to drawing NORDEX 02010 -1009101_Sandwich lay-up plan
370mm
根据图纸NORDEX 02010 - 1009101_夹芯结构定位泡沫和粘接后缘
pressure side must not contact eachwise during the gluing.
NR_FP_NR37.5_1141_前缘和后缘阻胶
上下模之间的粘接区域为4±2mm。所有粘接区域都用脱模布保护。除此之
外粘接前打磨粘接区域。
1:20.
3向布的铺层上出行褶皱