搜档网
当前位置:搜档网 › 复合型氧化絮凝剂深度处理制药废水的研究

复合型氧化絮凝剂深度处理制药废水的研究

KMnO4-PFS and KMnO4-PFS-PAC. The optimized results showed that the optimum mass fraction of KMnO4in KMnO4-PFS was 15%, and the optimum proportion of KMnO4-PFS-PAC was 14.95% KMnO4, 41.63% PAC and 43.42% PFS. The optimum mass fraction of KMnO4in KMnO4-PAC was 10%. However, for different kinds of wastewater, the treatment effect of several complex forms is different, when the specific gravity of refractory substances in water increases, the treatment effect will weaken.

Compared with KMnO4-PFS flocculant and KMnO4-PAC flocculant, the removal effect of KMnO4-PFS-PAC on COD and turbidity is between the optimum ratio of COD and turbidity, and the utilization ratio of potassium permanganate is also between the optimum ratio of KMnO4-PFS flocculant and KMnO4-PAC compound flocculant. However, in the advanced treatment of pharmaceutical wastewater, KMnO4-PFS complex flocculant has the best treatment effect, but it is found that the treatment cost of KMnO4-PFS-PAC is 0.2732 yuan / ton when the preliminary economic cost accounting is carried out.

It was found that the introduction of inorganic flocculant improved the oxidation ability of potassium permanganate and the utilization rate of potassium permanganate. But the addition of potassium permanganate weakens the neutralization ability of flocculant, and the turbidity removal rate can be maintained at more than 75% by adding PAM to assist coagulation.

Keywords: pharmaceutical wastewater, Compound flocculant, potassium permanganate, PAC, PFS

目录

摘要 ............................................................................................................................... I ABSTRACT .................................................................................................................... I I 第1章绪论 .. (1)

1.1 研究背景 (1)

1.2 制药废水处理现状 (1)

1.2.1 制药废水分类及特点 (1)

1.2.2 制药废水排放标准 (2)

1.2.3 制药废水深度处理的必要性 (3)

1.3 制药废水深度处理简介 (4)

1.3.1 高级氧化技术 (4)

1.3.2 物化技术 (4)

1.3.3 生物处理技术 (5)

1.3.4 其他 (5)

1.4 混凝机理及研究现状 (5)

1.4.1 混凝机理 (6)

1.4.2 混凝影响因素 (7)

1.4.3 絮凝剂种类 (8)

1.5 高锰酸钾在水处理中的应用 (9)

1.6 本课题的研究内容 (10)

第2章材料与方法 (12)

2.1 试验材料 (12)

2.1.1 试验用水 (12)

2.1.2 试验用仪器 (12)

2.1.3 试验用试剂 (12)

2.2 试验方法 (13)

2.2.1 试验测试分析方法 (13)

2.2.2 单因素试验 (16)

2.2.3 响应面试验 (16)

2.2.4 混料优化试验 (16)

第3章高锰酸钾与絮凝剂深度处理制药废水优化试验 (17)

3.1 引言 (17)

3.2 高锰酸钾深度处理制药废水试验 (17)

3.2.1 COD去除率单因素试验 (17)

3.2.2 高锰酸钾利用率单因素试验 (22)

3.2.3 氧化还原电位(ORP)影响因素 (25)

3.2.4 高锰酸钾氧化响应面 (27)

3.3 无机絮凝剂深度处理制药废水试验 (30)

3.3.1 絮凝剂投加量 (30)

3.3.2 初始pH值 (31)

3.3.3 温度 (32)

3.3.4 助凝剂PAM (33)

3.3.5 絮凝剂与pH值 (34)

3.3.6 絮凝剂处理条件优化 (36)

3.4 本章小结 (37)

第4章复合型氧化絮凝剂深度处理制药废水优化试验 (38)

4.1 引言 (38)

4.2 复配絮凝剂比例及制备 (38)

4.2.1 絮凝剂复配比例 (38)

4.2.2 氧化性絮凝剂制备 (38)

4.3 KMnO4-PAC絮凝剂深度处理制药废水 (39)

4.3.1 单因素试验 (39)

4.3.2 复配形式对ORP的影响 (42)

4.3.3 复配优化 (44)

4.4 KMnO4-PFS絮凝剂深度处理制药废水 (44)

4.4.1 单因素试验 (44)

4.4.2 复配形式对ORP的影响 (48)

4.4.3 复配优化 (49)

4.5 KMnO4-PFS-PAC复配混料优化试验 (49)

4.5.1 混料实验设计 (49)

4.5.2 COD去除率模型 (50)

4.5.3 浊度去除率模型 (52)

4.5.4 高锰酸钾利用率模型 (53)

4.6 不同复配絮凝剂处理效果比较 (54)

4.7 Zeta电位的变化 (54)

4.8 氧化型复剂去除污染物的强化机制 (56)

4.9 本章小结 (57)

第5章不同废水的处理效果及成本核算 (58)

5.1 引言 (58)

5.2水质对氧化型絮凝剂处理效果的影响 (58)

5.2.1 煤化工废水 (58)

5.2.2 乳品废水 (59)

5.2.3 水质对处理效果的影响 (61)

5.3 处理成本核算 (61)

5.3.1 所用药剂价格 (61)

5.3.2 废水处理成本 (61)

5.4 本章小结 (62)

结论与展望 (64)

参考文献 (66)

攻读学位期间发表的学术论文 (70)

哈尔滨工业大学学位论文原创性声明和使用权限 (71)

致谢 (72)

相关主题