GENERAL DATA
Life Expectancy
Minimum operations Mechanical 1 x 107
Electrical 1 x 105at 5 A 250 VAC Res.Operate Time (typical)8 ms at nominal coil voltage Release Time (typical)
5 ms at nominal coil voltage (with no coil suppression)
Dielectric Strength 2500 Vrms coil to contact
(at sea level for 1 min.)1000 Vrms between open contacts Insulation 1000 megohms min. at 20°C Resistance 500 VDC 50% RH
Dropout
Greater than 5% of nominal coil voltage Ambient Temperature
At nominal coil voltage
Operating
-40°C (-40°F) to 70°C (158°F) standard -40°C (-40°F) to 85°C (185°F) sensitive Storage
-40°C (-40°F) to 105°C (221°F)Vibration 0.062" (1.5 mm) DA at 10–50 Hz Shock 10 g operating, 100 g damage Enclosure P.B.T. polyester
Terminals
Tinned copper alloy, P.C.Max. Solder Temp.270°C (518°F)Max. Solder Time 5 seconds Max. Solvent Temp.80°C (176°F)Max. Immersion Time 30 seconds Weight
6 grams
Packing unit in pcs
50 per plastic tray / 500 per carton box
CONTACTS
Arrangement SPST (1 Form A)SPDT (1 Form C)Ratings
Resistive Load:
SPST-NO Standard coil Max. switched power:150 W or 1250 VA Max. switched current: 5 ADC or 10 AAC Sensitive coil Max. switched power:90 W or 750 VA Max. switched current: 3 A
SPDT
Max. switched power:90 W or 750 VA Max. switched current: 3 A
Max. switched voltage: 150 VDC* or 380 VAC
* Note: If switching voltage is greater than 30VDC,
special precautions must be taken.Please contact the factory
Rated Load UL, CUR
Form A
Standard coil
10 A at 125 VAC, Res., 30k cycles 5 A at 30 VDC / 250 VAC, 100k cycles
10 A LRA / 1.5 A FLA at 120 VAC, 100k cycles 1/10HP at 125 VAC, 100k cycles 1/6
HP at 250 VAC, 100k cycles Sensitive coil
5 A at 125 VAC, Res., 100k cycles 3 A at 30VDC / 250 VAC, 100k cycles Form C
3 A at 30 VDC / 250 VAC, 100k cycles
Material Silver cadmium oxide Resistance
< 100 milliohms initially
ZET TLER
electronics GmbH
Fax +49 89 800 97 200 https://www.sodocs.net/doc/108230955.html,
office@https://www.sodocs.net/doc/108230955.html, 0 97 800 89 +49 Tel. Germany Puchheim, D-82178 Junkersstrasse 3, 2005-03-08
NOTES
1.All values at 20°C (68°F).
2.Relay may pull in with less than “Must Operate” value.
3.Specifications subject to change without notice.
COIL
Power
At Pickup Voltage 253 mW standard coil (typical)
113 mW sensitive coil Max. Continuous 1.25 W at 20°C (68°F) ambient Dissipation
Temperature Rise 41°C (74°F) standard coil (at nominal voltage)22°C (40°F) sensitive coil Temperature
Max. 130°C (266°F)
SPDT SUBMINIATURE POWER RELAY
FEATURES ?Low cost
?10 Amp switching
?Epoxy sealed version available ?
UL, CUR file E44211
2005-03-08
ZET TLER
electronics GmbH
Fax +49 89 800 97 200 https://www.sodocs.net/doc/108230955.html,
office@https://www.sodocs.net/doc/108230955.html, 0 97 800 89 +49 Tel.
Germany
Puchheim, D-82178 Junkersstrasse 3, RELAY ORDERING DATA
STANDARD RELAYS
COIL SPECIFICATIONS
ORDER NUMBER*
Nominal Coil
Must Operate
Max. Continuous
Coil Resistance Form A (SPST)Form C (SPDT)VDC VDC VDC Ohm ± 10%
3
2.25
5.0
20
AZ767–1A–3D AZ767–1C–3D 5 3.758.355AZ767–1A–5D AZ767–1C–5D 6 4.510.080AZ767–1A–6D AZ767–1C–6D 9 6.7515.0180AZ767–1A–9D AZ767–1C–9D 129.020.0320AZ767–1A–12D AZ767–1C–12D 1813.530.0720AZ767–1A–18D AZ767–1C–18D 24
18.0
40.0
1,280
AZ767–1A–24D
AZ767–1C–24D
* Add suffix “E” for epoxy sealed version.
SENSITIVE RELAYS
COIL SPECIFICATIONS
ORDER NUMBER*
Nominal Coil
Must Operate
Max. Continuous
Coil Resistance Form A (SPST)VDC VDC VDC Ohm ± 10%
3
2.25
7.5
45
AZ767–1A–3DS 5 3.7512.5125AZ767–1A–5DS 6 4.515.0180AZ767–1A–6DS 9 6.7522.4400AZ767–1A–9DS 129.030.0720AZ767–1A–12DS 1813.544.71,600AZ767–1A–18DS 24
18.0
59.2
2,800
AZ767–1A–24DS