华为设备单臂路由配置简单实例

华为设备单臂路由配置实例：

拓扑图注：实验在华为模拟器eNSP内模拟进行。

1、交换机配置

sys

[Huawei]sys S1

[S1]vlan 10

[S1-vlan10]vlan 20

[S1-vlan20]int e0/0/1

[S1-Ethernet0/0/1]port link-type access

[S1-Ethernet0/0/1]port default vlan 10

[S1-Ethernet0/0/1] int e0/0/2

[S1-Ethernet0/0/2]port link-type access

[S1-Ethernet0/0/2]port default vlan 20

[S1-Ethernet0/0/2] int g0/0/1

[S1-GigabitEthernet0/0/1]port link-type trunk

[S1-GigabitEthernet0/0/1]port trunk allow-pass vlan 10 20

[S1-GigabitEthernet0/0/1]undo port trunk allow-pass vlan 1 //可省了此处，根据实际需要配置。

2、路由器配置

sys

[Huawei]sys R1

[R1]int g0/0/1.1

[R1-GigabitEthernet0/0/1.1]ip add 10.0.1.254 24

[R1-GigabitEthernet0/0/1.1]dot1q termination vid 10

[R1-GigabitEthernet0/0/1.1]arp broadcast enable

[R1-GigabitEthernet0/0/1.1]int g0/0/1.2

[R1-GigabitEthernet0/0/1.2]ip add 10.0.2.254 24

[R1-GigabitEthernet0/0/1.2]dot1q termination vid 20

[R1-GigabitEthernet0/0/1.2]arp broadcast enable

3、PC配置

PC1

PC2 4、PC1上ping测试