DSP报错信息

不上电连接
Error connecting to the target:
Error 0x80000240/-114
Fatal Error during: Initialization, OCS,
This error was generated by TI's USCIF driver.

SC_ERR_CTL_BUSY <-114>
The controller's commands are taking too long to complete.
This often implies one of the following errors:
1. The cable is disconnected near the controller.
2. The cable is disconnected near the target.
3. The JTAG clock has halted.
4. The target power has failed.
5. The controller is in an invalid state and should be reset.


Sequence ID: 0
Error Code: -114
Error Class: 0x80000240
I/O Port = 240

Board Name: F2812 SEEDXDS510PLUS Emulator
Cpu Name: TMS320C2800_0

Abort: Close Code Composer Studio.
Retry: Try to connect to the target again.
Cancel: Remain disconnected from the target
Diagnostic: Run diagnostic utility.



上电连接
Error connecting to the target:
Error 0x80000240/-171
Fatal Error during: Initialization, OCS,
This error was generated by TI's USCIF driver.

SC_ERR_REG_DETECT_CTLR <-171>
The wrong controller port value has been used.
A controller cannot be detected even though the
selected port does match the hardware configuration.
The standard 560 ports are 0x0, 0x1, 0x2 and 0x3.
The standard EVM ports are 0x0, 0x1, 0x2 and 0x3.
The standard DSK ports are 0x378, 0x278 and 0x3BC.
The standard 510 ports are 0x240, 0x280, 0x320 and 0x340.


Sequence ID: 0
Error Code: -171
Error Class: 0x80000240
I/O Port = 240

Board Name: F2812 SEEDXDS510PLUS Emulator
Cpu Name: TMS320C2800_0

Abort: Close Code Composer Studio.
Retry: Try to connect to the target again.
Cancel: Remain disconnected from the target
Diagnostic: Run diagnostic utility.

重试
Error connecting to the target:
Error 0x80000200/-1037
Fatal Error during: OCS,
PTI_ERR_EMU_CLOSE Error Occured at 0x00000000


Sequence ID: 0
Error Code: -1037
Error Class: 0x80000200
I/O Port = 240

Board Name: F2812 SEEDXDS510PLUS Emulator
Cpu Name: TMS320C2800_0

Abort: Close Code Composer Studio.
Retry: Try to connect to the target again.
Cancel: Remain disconnected from the target
Diagnostic: Run diagnostic utility.